电针
Electro-Acupuncture
操作方法 Manipulations
一般选取用侧肢体1-3 对腧穴，毫针刺入腧穴得气补泻后，将电针器上的输出电位器调到"0"值，把一对输出导线分别连接在两根针的针柄上，打开电源开关，选择需要的波型和频率，逐步调高输出电流至所需的电流量，使病人出现能耐受的酸麻感。通电时间一般为10-20分钟左右，针麻时间可更长。如刺激感减弱时，可适当加大刺激量，或断电1-2分钟后再通电，或改变频率，以保持恒定的刺激作用。治疗完毕，把电位器调至"0"值，关闭电源，撤去导线，起出毫针。医学全在线www.med126.com
In general, 1 to 3 pair of points are selected from the same side of the body or limbs, puncture the point with the filiform needle after the needling sensation occurs and reinforcing or reducing needling manipulation is conducted, set the output potentionmeter of the stimulator to "0", connect the two wires of the output respectively to the handles of the two needles, switch on the power supply, select the desired wave pattern and frequency, gradually increase the output current until the patient gets a tolerable soreness and numbness sensation. The electro-stimulation may last 10-20 minutes. When used in the acupuncture analgesia, the stimulation may be longer. In case the stimulative sensation decreases, the current may be increased properly, or turn off the power supply for 1-2 minutes, then reswitch it on or adjust the output current to have a constant stimulative effect. When the treatment is over, turn the potential to "0" and switch off the stimulator, disconnect the wires from the needles and withdraw the needles.
